BDS845FRS | BDS Suspension Coilover Upgrade Kit For Toyota Tundra TRD Pro 4WD | Fox 3.0 Internal Bypass Factory Race Series Shocks

Performance Leveling Kit for 2022–2026 Toyota Tundra TRD Pro Level Stance. Unmatched Control. Proven FOX Performance.

Unlock the potential of your Tundra TRD Pro with this high-performance Leveling Kit, engineered to deliver a more aggressive stance while maintaining factory ride quality. Designed for 2022–2026 Toyota Tundra TRD Pro models, this kit enhances capability and aesthetics without compromising reliability.

Recommended Tires & Wheels

(Trimming may be required)

• 285 / 75 with 18 x 9 and 6.25" in. Backspace
• 295 / 60 with 20 x 9 and 5.5 in. Backspace
• 305 / 55 with 17 x 9 and 5 in. Backspace

FOX 3.0 Factory Race Series Internal Bypass Shocks:

These top-tier shocks offer superior control and damping performance with position-sensitive technology. Built for high-speed off-road use and confident on-road comfort, the FOX 3.0 Internal Bypass Shocks are fully rebuildable and tunable for serious enthusiasts.

• Fox 3.0 Internal By-pass shocks with position sensitive damping which results in increased comfort while on road with superb off road performance.
• Dual Speed Compression (DSC) Adjuster Increases both low and high-speed compression levels up to 25%
• Easy twist knobs for Low-Speed and High-Speed Compression adjustment
• Provides added control and comfort for on-road use
• More aggressive damping for use off-road

BDS Upper Control Arms

High-strength UCAs from BDS improve suspension geometry and enhance front-end durability. Specifically designed to pair with performance coilovers, they increase travel while maintaining proper alignment.

Front Differential Drop Kit Included

The included diff drop ensures corrected front driveline angles for improved reliability and reduced wear during off-road excursions or heavy use.

Important Notes

1. Arms are designed to work with Fox Coilovers that require upper control arms and may not work with all aftermarket spacer lifts / lift kits (Will work with BDS 3” Lift).
2. Ball joint cap must be removed for maintenance of ball joint. Remove cap to access grease zerk. Grease at regular maintenance intervals.
3. For replacement ball joints, order BDS088200. Ball joints are not directional allow for max range of motion with 2”-3” lifts.

Installation

Specification