TF-RBWBR-0313 | Thuren Fabrication Rear Bumper DIY Weld Brackets For Ram

These brackets require you to supply the main 4" x 4" cross section, and complete the full build yourself. All tube, tube work, hitch parts, etc are all up to you and not supplied. The only parts supplied are the flat .25" steel laser cut brackets seen.

*ALL completed bumpers and welding photos shown are for reference only and are examples of what your finished bumper could look like if done properly.

Included:

• Fabrication Brackets (x14)

Not Included:

• 4" Tubing
• Hitch Receiver
• Wire Loom Brackets