DB3001-3 | DJM Suspension 3 Inch Drop Beams For Ford Ranger Pickup

For 1989-1997 Ford Ranger

SKU: DB3001-3

Pricing: $817.14

Description
Application List
Details
Shipping
Documents

Description

Give your Ford Ranger a lower, cleaner stance with these DJM drop beams made for a straightforward front suspension upgrade. This setup helps you get the look you want without cutting into your truck’s factory character.

These 3-inch DJM drop beams lower your 1989 to 1997 Ford Ranger by replacing the original beams, making the upgrade simple and direct.

You get a clean drop, proper fit, and a setup built for truck owners who want solid parts and a better stance. Shocks are not included with this lowering kit for the Ford Ranger. We recommend shock number 1415, sold separately.

Lowers front 3 inches
Direct beam replacement
Shock 1415 recommended

Built for a Straightforward Install

These Ford Ranger drop beams replace the factory beams, which helps make installation simpler for builders and truck owners. It is a practical option for getting the stance you want without extra guesswork.

Beam Instructions

Please take the time to read these installation instructions and check the Hardware Parts List to be sure you have all the listed parts.

These installation instructions are prepared for the professional installer with the proper equipment, tools and experience in suspension systems and safety.

Please read the warranty information (blue page enclosed). Complete your Product Warranty Card and mail it to DJM Suspension.

Please take a few minutes to fill out your installation helper (back side of warranty).

Accurate measurements BEFORE BEGINNING INSTALLATION will show any irregularities in your vehicle.

NEVER WORK UNDER TRUCK SUPPORTED BY A JACK ONLY!!! USE QUALITY JACK STANDS WHICH HAVE A RATING ADEQUATE FOR YOUR TRUCKS WEIGHT!!!

USE FACTORY COIL SPRINGS ONLY!! SHORTER COIL SPRINGS WILL CAUSE EXCESSIVE NEGATIVE CAMBER.

NOT DESIGNED FOR AIR BAGS.

INSTALLER MUST CHECK THAT THERE IS ABSOLUTELY NO CLEARANCE PROBLEMS BETWEEN THE WHEELS, THE SPINDLE, THE CALIPER, THE LOWER CONTROL ARMS AND ANY OTHER COMPONENT BEFORE DRIVING VEHICLE.

Installing DJM Dream Beams uses the same installation procedures as replacing a factory beam. Refer to your repair manual for guidelines. Factory shocks can be reused.

DO NOT ATTEMPT TO BEND YOUR NEW DJM DREAM BEAM TO CORRECT CAMBER. Aftermarket cam kits are available up to 3.5 degrees.

Note: Part# DB3003-3 is the only beam that has a press-in ball joint — all others are mounted in the spindle. Care must be taken not to bend the ball joint mounts when reinstalling the ball joints. The span between the ball joints should be supported in order not to bend the mounts.