1156 (19 LEDs on each bulb) Unidirectional LED Bulb - Amber
LED bulbs may cause some newer vehicles to indicate a bulb is burnt out (because of their low power consumption). Some cars indicate this by increasing the flash rate of the turn signals, some turn on a bad bulb indicator. This can be remedied with our Load Resistors wired across the turn signal bulbs to simulate a filament bulb load.
This 6 Ohm, 50 Watt resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb (2 Amp load). This will solve LED related turn signal problems such as hyper flashing or burnt out bulb indications. This LED Load Resistor can be use with most signal or brake light which uses SINGLE or DUAL FILAMENT LED light bulbs, like the 7443, 1157, 3157, 4157, 1156, 7440, 3156 etc.
Using included splice taps, connect one wire to ground and the other wire to the turn/brake hot wire. Splice taps allow for installation without cutting your turn signal wires.
Automotive LED Light Bulb Load Resistor Features:
-- Solve LED related turn signal problems such as hyper flashing or burnt out bulb indications.
-- Compact design for easy installation.
-- 6 Ohm 50 Watt resistors can be use will most import and domestic vehicles.
Don't get caught in the dark again...Light It Up WIth RECON!!!!!
***ATTENTION - VERY IMPORTANT MESSAGE BELOW***
These bulbs are sold individually which means only 1 bulb comes in each package. This means if you need a total of 4 bulbs, you must enter a qty of 4 before clicking the "add to cart" button.
- Item Requires Shipping
- 10.0 lbs.
- W6.0000” x H2.0000” x L6.0000”
Total Reviews (0)
Write the First Review!
You must login to post a review.
May We Suggest
- The Company Difference
- We're the ExpertsAsk us anything. We are the professionals!
- Largest SelectionIf you don't find the part, we'll get it for you!
- No Hassle ReturnsEasy returns or refunds